Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual page 50

3-14 WS2000 Wireless Switch System Reference Guide
The upper part of the screen is used to set up the VLAN type to be created.
1. Use the pull-down menu to select a
Port Based.
Port-based VLANs partitions traffic based on port on which the packet is received. The switch inspects
each packet, extracts the port on which it was received (from control information provided by the driver)
and processes the packet based on the port. The port is mapped to a subnet and each subnet is mapped
to a single VLAN. The switch processes the packet based on this mapping.
User-based VLAN traffic classification is performed only for Wireless traffic. The VLAN for a particular
MU is identified when the MU authenticates itself with the RADIUS server using a user ID and password.
The RADIUS server provides the VLAN ID corresponding to this MU and User ID information combination.
The switch processes the packet based on the VLAN ID provided by the RADIUS server.
For wired traffic, the classification as done in Port-based VLANs applies.
2. Use the pull-down menu to select a
the Trunk Port.
3. Enter the Default VLAN ID
VLAN ID must be one of the IDs assigned to the subnets if the
Type is User Based, then the
4. For each enabled Subnet, enter the
5. Enter a list of allowed VLANs between 1 and 4094 in the
will be allowed access through the WAN port. When entering multiple VLAN IDs, separate each ID with
a comma. When entering a range of VLAN IDs, separate the starting and ending values with a "-".
6. To enable filtering using IP, check the
when Trunk Port
appears. Set the appropriate filter and click
7. Click Ok on the VLAN Configuration screen to save changes.
VLAN Type
Trunk Port
to be used for packets that do not have the VLAN tag inserted. The default
Default VLAN ID
VLAN ID.
Enable IP Filtering
is set to Wan. To add an IP filter, click
Ok
for this switch. The two options are
for the switch. Only the WAN port can be configured as
VLAN Type
must be one from the Allowed VLANs
Allowed VLANs
check box. This option is only available only
IP Filtering button. The IP Filtering dialog
to close the dialog.
User Based and
is Port Based. If the VLAN
list.
box. The VLANs in this list