Ip Filtering; Mobile Unit Access Control List (Acl) - Motorola WS2000 - Wireless Switch - Network Management Device System Reference Manual

5.3.10 IP Filtering

IP based filtering allows administrators to configure Incoming and Outgoing IP filtering policies on packets
within the same Subnet / WLAN and between wired and wireless hosts.
To Configure IP Filtering for the WLAN:
1. Check the box marked
outbound traffic on the WLAN.
2. Click the

IP Filtering

3. Click the Add
the corresponding fields in the table.
4. Click the Filter Name
be unique for each filter rule that is added.
5. Click the Direction
Outbound on the WLAN. 'Incoming' traffic refers to traffic coming from an MU to the AP. 'Outgoing' traffic
refers to the traffic going from the AP to an MU.
6. Click the Action
in the chosen direction. 'Allow' will enable traffic to pass freely in the specified direction between the
APs and MUs. 'Deny' will prevent traffic from passing in the specified direction between the APs and
MUs.
7. Check the Default Inbound Deny
the MUs to the APs.
8. Check the Default Outbound Deny
from the APs to the MUs.
9. Click the OK
10.Click the Apply

5.3.11 Mobile Unit Access Control List (ACL)

Use this list to specify which mobile units can or cannot gain access to the WLAN. The list employs an
adoption rule for allowing or denying specific mobile units by way of exception.
1. Select Allow
in the table. If Allow is visible, the access criteria (MAC addresses) will be used to indicated which
Enable IP Filtering
button to display a sub-screen for filtering settings on the WLAN.
button to create a new filter in the table. The new filter can then be edited by clicking on
and provide a name or edit an existing name for the filter. The
field for the corresponding filter to specify if the filter applies to traffic Inbound or
field for the corresponding filter to specify if the filter will be set to Allow or Deny traffic
box to prevent traffic inbound on the WLAN from passing freely from
box to prevent traffic outbound on the WLAN from passing freely
button to return to the WLAN Security screen.
button the WLAN Security screen to commit the changes to the system.
or Deny from the pull-down menu. This rule applies to all mobile units except those listed
to turn on IP Address based filtering for inbound and
5-15
Wireless Configuration
Filter Name should