Table of Contents
Advertisement
Scroll down the list and locate Apache2. Right-click on the service and select Stop. Right-click on the same service
again and select Start.
4
If you did not install your HTTP server prior to installing the Spheras Storage Director server, your HTTP server
was not configured automatically during the installation process. To configure your HTTP server, see Appendix A
Manually Configuring HTTP Servers on page 201.
5
Set up a user ID on the system that is running the Spheras Storage Director server. The Spheras Storage Director
server uses existing user IDs on the server running it to authenticate users and assign authorities to them. See 3.1
Security access levels on page 45.
6
Stop and restart the Spheras Storage Director Server service.
7
Start-> Settings-> Control Panel-> Administrative Tools ->Services
Scroll down the list and locate the Spheras Storage Director Server. Right-click on the service and select Stop.
Right-click on the same service again and select Start.
2.4.2
Client Component
The Spheras Storage Director Client requires a fully-configured, JRE-enabled web browser. Each time that a Spheras
Storage Director Client connects to a Spheras Storage Director Server the browser configuration is checked to ensure
that an appropriate level of the JRE plugin is installed. If an appropriate level of the JRE plugin is not found, the "Java
Runtime Environment Plugin Installation" starts automatically. For more information, see 2.8 Starting the Spheras
Storage Director Client on page 43.
2.5
Linux: Post-Installation Configuration and Verification
2.5.1
Server Component
Verify or perform the following on systems that have the server component of the Spheras Storage Director installed:
1
Edit the /usr/local/apache2/conf/httpd.conf file and ensure that the ServerName and any aliases are correct. For
more information, see A.1.3 Linux - Manually Configuring an Apache HTTP Web Server on page 208.
2
Edit the /etc/hosts file and ensure that it contains:
•
An entry for the server itself. The default setting is the loopback value of 127.0.0.1 for the name localhost.
•
The static IP address and name of the Spheras Storage Director Server. (This is necessary for Spheras Storage
Director Clients to communicate with the server.)
3
Verify your HTTP server installation by stopping and restarting your HTTP server:
Open a Terminal Window and type the following (these examples assume that you accepted the default path during
installation):
cd /usr/local/apache2/bin
then type,
./apachectl stop
followed by:
./apachectl start
© 2003, Adaptec, Inc.
37
Advertisement
Table of Contents
