Table of Contents
Advertisement
388
389
390
391
392
393
394
Table 2
RAID Controller Event Codes
© 2003, Adaptec, Inc.
Name
MLXEV_CTLDEV_DEAD
Description Controller is dead. System is disconnecting from this controller.
Cause
Hardware failure.
Action
Contact your service representative.
Address
ctl: 0
Severity
0 (Critical)
Source
InP_old
Name
MLXEV_CTLDEV_RESET
Description Controller has been reset.
Cause
Controller received a reset command.
Action
If this was an unexpected event, refer to the enclosure manufacturer's
service manual.
Address
ctl: 0
Severity
4 (Information)
Source
ExPro InP_old
Name
MLXEV_CTLDEV_FOUND
Description Controller is found.
Cause
New controller has been installed.
Management software has restarted.
System has rebooted.
Action
None
Address
ctl: 0
Severity
4 (Information)
Source
InP_old
Name
MLXEV_CTLDEV_GONE
Description Controller is gone. System is disconnecting from this controller.
Cause
Controller has been powered off.
Controller has been removed from the system.
Action
None
Address
ctl: 0
Severity
0 (Critical)
Source
InP_old
Name
MLXEV_CTLDEV_BBU_FOUND
Description Battery present.
Cause
A battery module has been detected and is now operational.
Action
None
Address
ctl: 0
Severity
4 (Information)
Source
ExPro InPro
Name
MLXEV_CTLDEV_BBU_POWER_LOW
Description Battery power low.
Cause
Battery power is low.
Action
If this message occurs without power failure, replace the battery.
Address
ctl: 0
Severity
2 (Error)
Source
ExPro InPro
Name
MLXEV_CTLDEV_BBU_POWER_OK
Description Battery power OK.
Cause
Battery has enough power to enable the write data cache.
Action
None
Address
ctl: 0
Severity
4 (Information)
Source
ExPro InPro
163
Advertisement
Table of Contents
