Table 116
VLAN Configuration commands
Command
show vlan [<1-4095>]
IMPORTANT:
All ports must belong to at least one VLAN. Any port which is removed from a VLAN and which
is not a member of any other VLAN is automatically added to default VLAN 1. You cannot remove a port from
VLAN 1 if the port has no membership in any other VLAN. Also, you cannot add a port to more than one
VLAN unless the port has VLAN tagging turned on.
Layer 3 configuration
The following table describes basic Layer 3 Configuration commands. The following sections provide more detailed
information and commands.
Table 117
L3 Configuration commands
Command
interface ip {<1-256>}
*route-map <1-32>
*router rip
*router ospf
*router vrrp
*ip router-id <IP address>
show layer3
* indicates command modes that apply only to the GbE2c Ethernet Blade Switch.
IP interface configuration
The switch can be configured with up to 256 IP interfaces. Each IP interface represents the switch on an IP subnet on
your network. The IP Interface option is disabled by default.
The following table describes the IP Interface Configuration commands.
Table 118
IP Interface Configuration commands
Command
interface ip {<1-256>}
ip address {<IP address>}{<IP
netmask>}
vlan {<1-4095>}
enable
Description
Displays the current VLAN configuration.
Command mode: All
Description
Enter IP Interface mode.
Command mode: Global configuration
Enter IP Route Map mode.
Command mode: Global configuration
Enter Router RIP mode.
Command mode: Global configuration
Enter Router OSPF mode.
Command mode: Global configuration
Enter VRRP configuration mode.
Command mode: Global configuration
Sets the router ID.
Command mode: Global configuration
Displays the current IP configuration.
Command mode: All except User EXEC
Description
Enter IP interface mode.
Command mode: Global configuration
Configures the IP address and mask of the switch interface using
dotted decimal notation.
Command mode: Interface IP
Configures the VLAN number for this interface. Each interface can
belong to one VLAN, though any VLAN can have multiple IP
interfaces in it.
Command mode: Interface IP
Enables this IP interface.
Command mode: Interface IP
Configuration Commands 110