Show Volume-Maps - HP P2000 Reference Manual

show volume-maps

Description Shows mapping information for a specified volume or for all volumes.
Syntax
show volume-maps [volume]
Parameters volume
Optional. Name or serial number of the volume to show mappings for. For volume syntax, see
Command syntax
Output Serial Number
Volume serial number
Name
Volume name
Ports
Controller host ports that the mapping applies to
LUN
LUN used to access the volume
Access
Type of host access to the volume:
•
read-write
•
read-only
•
no-access
•
not-mapped
Host-Port-Identifier
• FC and SAS: Host WWPN
• iSCSI: Host initiator node name (typically the IQN)
• all other hosts for the volume's default mapping
Nickname
Host nickname, or blank if not set or for all other hosts
Profile
• Standard: The host allows LUN 0 to be assigned to a mapping.
OpenVMS: The host does not allow LUN 0 to be assigned to a mapping.
•
• HP-UX: The host allows LUN 0 to be assigned to a mapping and uses Flat Space Addressing.
Example Show all volume mappings:
# show volume-maps
Volume View [Serial Number (SN) Name (v1) ] Mapping:
Ports
-----------------------------------------------------------------------
A1,A2,B1,B2 501
Volume View [Serial Number (SN) Name (v2) ] Mapping:
Ports
------------------------------------------------------------------
A1,B1
A1
Basetypes • volume-view
• status
on page 21. If this parameter is omitted, information for all volumes is shown.
LUN Access
read-write
LUN Access Host-Port-Identifier Nickname Profile
101 read-write 207000c0ff001121
100 read-only 207000c0ff001122
not-mapped all other hosts
Host-Port-Identifier Nickname Profile
all other hosts
Host2
Host1
HP P2000 G3 MSA System CLI Reference Guide 267
Standard
Standard
Standard
Standard