HP P2000 Reference Manual page 204

SIP-Gateway
iSCSI only. Secondary gateway IP address. This field is only displayed during failover.
SIP-Netmask
iSCSI only. Secondary subnet mask IP address. This field is only displayed during failover.
MAC(S)
iSCSI only. Secondary MAC address. This field is only displayed during failover.
Example Show port information for a system with two FC ports:
# show host-parameters
Ports Media
----------------------------------------------------------------
A1 FC(L)
Topo(C) PID
------------
Loop
A2 FC(-)
Topo(C) PID
------------
Loop
----------------------------------------------------------------
Show port information for a system with two iSCSI ports:
# show host-parameters
Ports Media
------------------------------------------------------------------------------
A1 iSCSI
IP-Ver PIP
--------------------------------------------------------------
IPv4
A2 iSCSI
IP-Ver PIP
--------------------------------------------------------------
IPv4
------------------------------------------------------------------------------
Show port information for a system with two SAS ports:
# show host-parameters
Ports Media
--------------------------------------------------------------
A1 SAS
Topo(C) Width
--------------
Direct
A2 SAS
--------------------------------------------------------------
Topo(C) Width
--------------
Direct
--------------------------------------------------------------
• port
Basetypes
• status
204 Alphabetical list of commands
Target ID
WWPN
0
WWPN
Target ID
IQN
PIP-Gateway PIP-Netmask MAC
10.134.9.100 10.134.0.1
IQN
PIP-Gateway PIP-Netmask MAC
10.134.9.101 10.134.0.1
Target ID
WWPN
4
WWPN
4
Status Speed(A) Speed(C)
Up 8Gb
Disconnected
Status
Up
255.255.0.0 00:C0:FF:29:00:24
Up
255.255.0.0 00:C0:FF:29:00:23
Status Speed(A) Speed(C)
Disconnected
Disconnected
Auto
Auto
Speed(A) Speed(C)
1Gb 1Gb
1Gb 1Gb