Show Priorities - HP P2000 Reference Manual

show priorities

Description Shows a specified snap pool's snapshot retention priorities. Snap-pool priorities, in conjunction with
snapshot priorities, determine which snapshots are retained if system resource limitations require
some snapshots to be automatically deleted.
Priority values are 0–65535. Lower-priority snapshots will be deleted before higher-priority
snapshots.
Syntax
show priorities snap-pool
Parameters snap-pool
Name or serial number of the snap pool.
Output Attribute Name
•
Standard Snapshot
• Volume Copy Snapshot: A snapshot that is being used to copy data from a source volume to
a destination volume. This attribute is temporary for the duration of the volume-copy process.
•
Replication Snapshot
• Replicating Snapshot: A snapshot that is being replicated to a secondary volume. This
snapshot is required in order to resume the replication. The attribute is temporary for the duration
of the replication process.
Common Sync Point Snapshot: The latest snapshot that is copy-complete on all secondary
•
volumes. It identifies a common point in time that is known by all destinations.
• Only Sync Point Snapshot: The only sync point that is available on at least one secondary
volume. If this snapshot is removed, then the next replication requires a full sync to be performed.
• Queued Snapshot: A snapshot that was taken for remote replication but is queued waiting for
the previous replications to complete.
Priority
Retention priority for the corresponding attribute.
Example Show priorities for snap-pool SP1:
# show priorities SP1
Attribute Name
-----------------------------------------------
Standard Snapshot
Volume Copy Snapshot
Replication Snapshot
Replicating Snapshot
Common Sync Point Snapshot
Only Sync Point Snapshot
Queued Snapshot
-----------------------------------------------
Basetypes • attribute-priorities
• status
See also • set priorities
• show snap-pools
Priority
0x6000 (default)
0xa000 (default)
0x4000 (default)
0xc000 (default)
0x8000 (default)
0xe000 (default)
0x2000 (default)
HP P2000 G3 MSA System CLI Reference Guide 221