Remote - HP P2000 Reference Manual

remote

Description Runs a command on a remote system that is associated with the local system. If the command cannot
connect to remote controller A, it tries to connect to remote controller B; if unsuccessful, the remote
command is not run. Output is displayed in console or XML API format depending on the local
system's setting.
Syntax
remote
system
command
Parameters system
Name or network-port IP address of the remote system.
command
Any CLI command that is valid for the remote user's access level.
Example Run the show vdisks command on remote system System2:
# remote System2 show vdisks
Name Size
Job%
-------------------------------------------------------------------------
VD1 587.1GB
41%
VD2 146.5GB
-------------------------------------------------------------------------
See also • show remote-systems
100 Alphabetical list of commands
Free Own
Serial Number Drive Spin Down
116.7GB B
SN Disabled
95.7GB A
SN Enabled - all spinning
Pref RAID Disks
Spin Down Delay
B RAID50 6
0
A RAID0 2
1
Spr Chk Status Jobs
0 64k FTOL VRSC
0 64k UP