Set Job-Parameters - HP P2000 Reference Manual

set job-parameters

Description Sets parameters for background vdisk scrub, partner firmware upgrade, and other jobs.
Syntax
set job-parameters
[background-scrub enabled|disabled|on|off]
[partner-firmware-upgrade enabled|disabled|on|off]
[utility-priority low|medium|high]
Parameters background-scrub enabled|disabled|on|off
Optional. Sets whether disks in vdisks are automatically checked for disk defects to ensure system
health. The interval between background vdisk scrub finishing and starting again is 24 hours.
partner-firmware-upgrade enabled|disabled|on|off
Optional. Sets whether versions of firmware components are monitored and automatically upgraded
on the partner controller.
utility-priority low|medium|high
Optional. Sets the priority at which jobs run with respect to I/O operations competing for the
system's processors. This affects vdisk verification and reconstruction, but not background scrub.
Example Enable background scrubbing of vdisks and disable partner firmware upgrade:
# set job-parameters background-scrub on partner-firmware-upgrade off
Info: Command completed successfully. - Parameter 'background-scrub' was set to
'on'.
Info: Command completed successfully. - Parameter 'partner-firmware-upgrade' was
set to 'off'.
Success: Command completed successfully. - The settings were changed
successfully.
See also • scrub vdisk
• set advanced-settings
• show job-parameters
HP P2000 G3 MSA System CLI Reference Guide 143