HP StorageWorks P2000 Installation Instructions

HP StorageWorks

Controller Module Installation

Instructions
This document details procedures for installing a con-
troller module in HP StorageWorks array enclosures.
© Copyright 2009, 2010 Hewlett-Packard Development Company,
L.P.
Second edition: March 2010
The information in this document is subject to change without notice.
Printed in the US.
www.hp.com
*590339-004*

About this document

Illustrations in this document show generic representations of modules
and enclosures; procedures are the same for all modules shipped
with this document.
The Storage Management Utility (SMU) and the Command Line Inter-
face (CLI) can be used to manage the enclosure. Tasks in this docu-
ment demonstrate using the SMU.
For the latest product documentation, see the HP website at
www.hp.com/support/manuals. Under the storage banner, navigate
to the page for your storage enclosure.

Before you begin

Observe the following:
CAUTION:
Removing a module from an operational enclosure significantly
changes air flow within the enclosure. Openings must be
populated for the enclosure to cool properly. Leave modules
in the enclosure until a replacement is available.
Parts can be damaged by electrostatic discharge; use proper
anti-static protection. Keep parts in electrostatic containers
until needed and ensure you are properly grounded when
touching static-sensitive components.
IMPORTANT:
When two controllers are installed in an enclosure, they must
be the same model. Mixing controller types in the same
enclosure is not supported.
NOTE:
To reduce impact on system performance, perform all
maintenance tasks during periods of low system activity or
during a system maintenance window.
The following illustration shows controller module locations:
1. Controller A
Page 1
http://
2. Controller B