Replicate Volume - HP P2000 Reference Manual

replicate volume

Description Creates a replication snapshot of the specified volume and initiates a replication operation. This
command can follow a
If the snapshot you want to replicate already exists, use the
NOTE: If replication requests are sent to a secondary system whose temporary replication license
has expired, the requests are queued but are not processed, and the secondary system reports event
472. If this condition occurs, check for this event in the event log, event-notification emails, and
SNMP traps. To continue using replication, purchase a permanent replication license.
Syntax
replicate volume
[set replication-set]
snapshot replication-snapshot
[preserve-snapshot external-snapshot]
volume
Parameters set replication-set
Optional. Name or serial number of the replication set.
snapshot replication-snapshot
Name for the new replication snapshot.
preserve-snapshot external-snapshot
Optional. Name of the external snapshot to use as the source for this replication. This preserves the
snapshot that is being used to replicate the volume as an external snapshot; otherwise, the snapshot
is converted to a replication snapshot.
volume
Name or serial number of the primary volume to replicate. If the name is not unique across
replication sets, specify the set parameter.
Example Replicate volume MV1 and name the replication snapshot RepSnap1:
# replicate volume snapshot RepSnap1 MV1
Success: Replication Initiated.
See also • show replication-sets
• show replication-volumes
create replication-set command that did not specify to initiate replication.
replicate snapshot
HP P2000 G3 MSA System CLI Reference Guide 103
command instead.