HP P2000 Reference Manual page 219

SIP-Netmask
iSCSI only. Secondary subnet mask IP address. This field is only displayed during failover.
MAC(S)
iSCSI only. Secondary MAC address. This field is only displayed during failover.
Example Show port information for a system with two FC ports:
# show ports
Ports Media
----------------------------------------------------------------
A1 FC(L)
Topo(C) PID
------------
Loop
A2 FC(-)
Topo(C) PID
------------
Loop
----------------------------------------------------------------
Show port information for a system with two iSCSI ports:
# show ports
Ports Media
------------------------------------------------------------------------------
A1 iSCSI
IP-Ver PIP
--------------------------------------------------------------
IPv4
A2 iSCSI
IP-Ver PIP
--------------------------------------------------------------
IPv4
------------------------------------------------------------------------------
Show port information for a system with two SAS ports:
# show ports
Ports Media
--------------------------------------------------------------
A1 SAS
Topo(C) Width
--------------
Direct
A2 SAS
--------------------------------------------------------------
Topo(C) Width
--------------
Direct
--------------------------------------------------------------
Basetypes • port
• status
See also • set host-parameters
Target ID
WWPN
0
WWPN
Target ID
IQN
PIP-Gateway PIP-Netmask MAC
10.134.9.100 10.134.0.1
IQN
PIP-Gateway PIP-Netmask MAC
10.134.9.101 10.134.0.1
Target ID
WWPN
4
WWPN
4
Status Speed(A) Speed(C)
Up 8Gb
Disconnected
Status
Up
255.255.0.0 00:C0:FF:29:00:24
Up
255.255.0.0 00:C0:FF:29:00:23
Status Speed(A) Speed(C)
Disconnected
Disconnected
HP P2000 G3 MSA System CLI Reference Guide 219
Auto
Auto
Speed(A) Speed(C)
1Gb 1Gb
1Gb 1Gb