HP P2000 Reference Manual page 50

secondary-address ip=IPs|wwnn=WWNNs|wwpn=WWPNs
Optional if the MCs can communicate and the remote-system parameter is specified; required if
the MC cannot communicate and a replication-prepared volume is specified. Specifies host ports on
the remote system by IP address, World Wide Node Name, or World Wide Port Name. An IP
address value can include a port number; for example, 10.134.2.1:3260. Multiple values must be
separated by commas and no spaces; for example: ip=10.134.2.1,10.134.2.2.
set name
Optional. Name for the new replication set. The name is case sensitive; cannot include a comma,
double quote, or backslash; and can have a maximum of 20 bytes. A name that includes a space
must be enclosed in double quotes. If this parameter is omitted, the set is named
rsprimary-volume.
snapshot snapshot
Optional. Name for the replication snapshot that will be created during the replication process. A
name is case sensitive; cannot include a comma, double quote, or backslash; and can have a
maximum of 20 bytes. A name that includes a space must be enclosed in double quotes. Specifying
this parameter will start the initial replication.
primary-volume
Name or serial number of a standard or master volume to use as the primary volume.
Example For two systems connected with FC links, set up replication from local standard volume Data to
remote vdisk VD1 in remote system System2:
# create replication-set link-type FC remote-system System2 remote-vdisk VD1
Data
Info: Snap pool spData was created for volume Data.
Info: Verifying that the secondary volume was added, this may take a couple of
minutes...
Info: Command completed successfully. (Data) - Converted the volume to a master
volume.
Info: Command completed successfully. (rData) - Secondary volume created.
Info: Command completed successfully. (Data) - The primary volume prepared for
replication.
Info: Command completed successfully. (rData) - Started adding the secondary
volume.
Info: Command completed successfully. (rData) - Added secondary volume.
Success: Command completed successfully. (Data) - The primary volume is ready
for replication.
For two systems connected with FC links, set up replication from local master volume Source to
remote replication-prepared volume Dest:
# create replication-set link-type FC remote-system System2 remote-volume Dest
Source
For two systems whose MCs aren't currently connected, set up replication from local master volume
MV to a remote replication-prepared volume:
# create replication-set primary-address wwpn=207000c0ffd52c31,217000c0ffd52c31
remote-volume 00c0ffda421f000089b16b4d01000000 secondary-address
wwpn=207000c0ffd52c31,217000c0ffd52 MV
For two systems whose MCs aren't currently connected but will use iSCSI links, set up replication from
local master volume MV to a remote replication-prepared volume:
# create replication-set link-type iSCSI primary-address ip=10.134.9.1
remote-volume 00c0ffda421f000089b16b4d01000000 secondary-address
ip=10.134.11.10,10.134.11.11 MV
Create a local replication set using existing master volume Personnel as the primary volume and
a new volume in vdisk vd1 for the secondary volume:
# create replication-set link-type FC remote-vdisk vd1 Personnel
50 Alphabetical list of commands