Executing The Diagnostic Test - Toshiba Satellite A10 Maintenance Manual

3.2 Executing the Diagnostic Test

3.2
To start the DIAGNOSTIC PROGRAM, follow these steps:
1. Turn off the computer and connect a USB FDD to the computer. Insert the
2. Turn on the computer by pressing the power switch while pressing U. The following
NOTE: To exit the DIAGNOSTIC TEST MENU, press the Esc key. If a test program is in
progress, press Ctrl + Break to exit the test program. If a test program is in progress,
press Ctrl + C to stop the test program.
* When no built-in FDD is mounted, begin the test program in the following procedure:
1. Turn off the power of the PC.
2. Connect a USB FDD to the PC and insert the test program in the USB FDD.
3. Press the power button while pressing U. Then, the test program starts.
Satellite A10/TECRA A10/Satellite Pro A10 Maintenance Manual (960-445)
Downloaded from www.Manualslib.com
Executing the Diagnostic Test
Diagnostics disk (No.1) in the floppy disk drive.
menu will appear:
TOSHIBA Personal Computer XXXXXX DIAGNOSTICS
version X.XX (C) Copyright TOSHIBA Corp. 20XX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 -
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
manuals search engine
3 Tests and Diagnostics
3-3