Sharp MX-3114N Operation Manual page 570

(1)
Scan/Special Modes
Program
4
Timer
Job
Build
Original
Count
Press the [COLOUR START] key or the [BLACK & WHITE START] key to scan the
first set of originals.
5
If the destination is an Internet fax destination, press the [BLACK & WHITE START] key.
To cancel scanning...
Press the [STOP] key (
Insert the next set of originals and press the [COLOUR START] key or the
[BLACK & WHITE START] key.
Press the [START] key pressed in step 5.
6
Repeat until all originals have been scanned.
To cancel scanning...
Press the [STOP] key (
Place next original.
Press [Start].
When finished, press [Read-End].
7
• If no action is taken for one minute after the confirmation screen appears, scanning automatically ends and the
transmission is reserved.
• The [Configure] key can be touched to change the exposure, resolution, scan size, and send size for each original
page scanned. However, when Job Build is used in combination with "2in1" in the special modes, only the exposure
can be changed when scanning each even-numbered page of the original pages.
If the memory becomes full during scanning, a message will appear and the transmission will be cancelled.
To cancel the job build function....
Touch the [Job Build] key in the screen of step 4 so that it is not highlighted.
(2)
OK
Dual Page
Erase
Scan
1
Suppress
Card Shot 2
Background
Slow Scan
Mixed Size
Original Mode
File Quick File
) to cancel the operation.
) to cancel the operation. All scanned data will be cleared.
(Pg.No.x)
Configure Read-End
Select job build mode.
(1) Touch the [Job Build] key so that it is
highlighted.
(2) Touch the [OK] key.
Touch the [Read-End] key.
5-87
SCANNER/INTERNET FAX
Contents