Auto Colour Calibration - Sharp MX-3114N Operation Manual

Auto Colour Calibration

This is used to perform automatic colour correction when the colour in colour printing is off. The machine prints a test
patch, the test patch is scanned, and the colour is automatically corrected.
After the [Execute] key is touched and a test patch is printed, a message appears prompting you to begin automatic
calibration. Place the test patch on the document glass as shown below (so that the thin line at the edge of the page is to
the left).
Lay copy paper (about five sheets) that is the same size as the test patch on top of the placed test patch, gently close
the automatic document feeder, and touch the [Execute] key.
• Before executing Auto Colour Calibration, check to see if the registration adjustment is correct. If the registration
adjustment is not correct, perform
• If the colour is still off after performing Auto Colour Calibration, repeating Auto Colour Calibration once again may improve
the colour.
Thin line
"Registration Adjustment" (page 7-68).
7-80
SYSTEM SETTINGS
Contents