Sending An Image At A Specified Time (Timer Transmission) - Sharp MX-3114N Operation Manual

SENDING AN IMAGE AT A SPECIFIED TIME
(Timer Transmission)
This function lets you specify a time at which a transmission or broadcast transmission will automatically take place.
Transmission begins automatically at the specified time.
Set a transmission to
take place at 20:00
• When a timer transmission is stored, keep the main power switch in the "on" position. If the main power switch is in the "off"
position at the specified time, transmission will not take place.
• When performing a timer transmission, you must scan the original into memory when you set up the transmission. It is not
possible to leave the document in the auto document feeder or on the document glass and have it scanned at the specified
time of transmission.
• Settings selected for a timer transmission (exposure, resolution, special modes, etc.) are automatically cleared after the
transmission is finished. (However, when the document filing function is used, the scanned original and settings are stored
on the built-in hard drive.)
• This function cannot be used in USB memory mode.
Place the original.
1
Place the original face up in the document feeder tray, or face down on the document glass.
Specify the destination.
2
☞
ENTERING DESTINATIONS
Select the special modes.
(1) Touch the tab of the mode that you wish to use.
3
(2) Touch the [Special Modes] key.
(3) Touch the [Timer] key.
☞
SPECIAL MODES
(page 5-18)
(page 5-71)
At 20:00, the transmission
begins automatically
5-79
SCANNER/INTERNET FAX
Contents