Sharp MX-3114N Operation Manual page 539

Specifying the original scan size (by paper size)
If the original is a non-standard size or you wish to change the scan size, touch the [Original] key to specify the original
size manually. Place the original in the document feeder tray or on the document glass and follow the steps below.
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
1
(2) Touch the [Original] key.
The automatically detected original size appears to the right of the [Original] key.
☞
IMAGE SETTINGS
Scan/Original
Scan Size
Auto
2
2-Sided 2-Sided
Booklet Tablet
Scan/Original
Auto
Manual
Manual
A5
A5R
B5
3
216x340 216x343
Size Input
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 1000 mm (39-3/8") (the maximum height is 297 mm (11-5/8")).
☞
TRANSMITTABLE ORIGINAL SIZES
• To specify an Inch size for the scan size, touch the [AB
scan size.
Scan/Original
Scan Size
B5
4
2-Sided 2-Sided
Booklet Tablet
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
(page 5-53)
OK
100% Send Size
A4 Auto
Image Orientation
(1) (2)
OK
B5R B4
AB
A4 A3
Inch
A4R Long Size
OK
100% Send Size
Auto
Image Orientation
Touch the [Scan Size] key.
Specify the scan size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
(page 5-17)
Inch] key to highlight the [Inch] side and then specify the
Touch the [OK] key.
5-56
SCANNER/INTERNET FAX
Contents