Sharp MX-3114N Operation Manual page 124

3
• Up to 999 copies (sets) can be set.
• A single copy can be made even if "0" appears for the number of copies.
If an incorrect number of copies is set...
Press the [CLEAR] key (
Press the [COLOUR START] key or the [BLACK & WHITE START] key.
Normally copying will start.
Depending on the copy settings (2-sided copying, etc.), copying may not begin until all originals have been scanned. In this
4
case, go to the next step.
Even if a colour mode is selected, copying will take place in black and white if the [BLACK & WHITE START] key is
pressed.
Remove the original and place the next original, and then press the [COLOUR
START] key or the [BLACK & WHITE START] key.
5
Repeat this step until all originals have been scanned.
For the second original and following originals, use the same [START] key as you did for the first original.
Place next original. Press [Start].
When finished, press [Read-End].
6
To cancel scanning of the original and copying...
Press the [STOP] key (
7
Special Modes
2-Sided Copy
Plain
A4
) and then enter the correct number.
Read-End
).
2-15
Set the number of copies (number of
sets) with the numeric keys.
Touch the [Read-End] key.
COPIER
Contents