Daylight Saving Time Examples; Selecting A Display Language - Cisco WIP310 - iPhone Wireless VoIP Phone Administration Manual

Configuring Regional Parameters and Supplementary Services
Localizing Your IP Phone
NOTE
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide

Daylight Saving Time Examples

The following example configures daylight savings time for the U.S, adding one
hour starting at midnight on the first Sunday in April and ending at midnight on the
last Sunday of October; add 1 hour (USA, North America):
start=4/1/7/0:0:0;end=10/31/7/0:0:0;save=1
start=4/1/7;end=10/-1/7;save=1
start=4/1/7/0;end=10/-1/7/0;save=1
The following example configures daylight savings time for Egypt, starting at
midnight on the last Sunday in April and ending at midnight on the last Sunday of
September:
start=4/-1/7;end=9/-1/7;save=1 (Egypt)
The following example configures daylight savings time for New Zealand, starting
at midnight on the first Sunday of October and ending at midnight on the third
Sunday of March. This only applies to countries that recognize daylight savings
time.
start=10/1/7;3/22/7;save=1 (New Zealand)
The following example reflects the new change starting March 2007. DST starts on
the second Sunday in March and ends on the first Sunday in November:
start=3/8/7/02:0:0;end=11/1/7/02:0:0;save=1

Selecting a Display Language

This section describes how to localize the SPA 500 Series IP Phone display
language. You can define up to nine languages, in addition to English, to be
available and host the dictionaries for each of the languages on the HTTP or TFTP
provisioning server. Language support follows Cisco dictionary principles.
The WIP310 does not support localization; however, daylight savings time
adjustment is supported.
Use the Language Selection parameter to select the phone's default display
language. The value must match one of the languages supported by the dictionary
server. The script (dx value) is as follows:
• <Language_Selection ua="na">
• </Language_Selection>
7
165