To replace the component:
Open the release latch and prepare the hard drive for installation.
1.
Install the hard drive.
2.
Determine the status of the hard drive from the hot-plug hard drive LEDs
3.
LED
combinations" on page 74).
Resume normal server operations.
4.
Power button/LED board cable
To remove the component:
Power down the server blade (on page 28).
1.
Remove the server blade (on page 28).
2.
Remove the access panel
3.
Open the flip-top compartment.
4.
All manuals and user guides at all-guides.com
("Access
panel" on page 29).
("SAS and SATA hard drive
Removal and replacement procedures 31