Chapter 4 Configuring The Gigabit Ethernet Ports - Cisco 2948G - Catalyst Switch Hardware Installation Manual

Configuring the Gigabit Ethernet Ports
Before you install, operate, or service the system, read the Site Preparation and
Warning
Safety Guide. This guide contains important safety information you should know
before working with the system. Statement 200
Only trained and qualified personnel should be allowed to install, replace, or
Warning
service this equipment. Statement 1030
This chapter describes how to configure the Gigabit Ethernet ports on the Catalyst
2948G and 2980G switches and how to configure the small form-factor-pluggable
(SFP) module slot on the Catalyst 2948G-GE-TX switches. The chapter contains
these sections:
•
•
The Gigabit Ethernet ports can be configured with any combination of GBICs.
The Gigabit Ethernet ports on these modules are used primarily for backbone
interconnection of other high-performance switches and routers.
78-6286-05
Installing, Removing, and Maintaining GBICs, page 4-2
Connecting To an SFP Module, page 4-12
Catalyst 2984G, 2948G-GE-TX, and 2980G Switch Hardware Installation Guide
C H A P T E R
4
4-1