Taiwan Battery Recycling Notice; Power Cords; Japanese Power Cord Notice - HP A7533A - Brocade 4Gb SAN Switch Base Hardware Reference Manual

For more information about battery replacement or proper disposal, contact an HP authorized reseller
or service provider.

Taiwan battery recycling notice

Power cords

The power cord set must meet the requirements for use in the country where the product was purchased.
If the product is to be used in another country, purchase a power cord that is approved for use in that
country.
The power cord must be rated for the product and for the voltage and current marked on the product
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage
and current rating marked on the product. In addition, the diameter of the wire must be a minimum
2
of 1.00 mm or 18 AWG, and the length of the cord must be between 1.8 m (6 ft) and 3.6 m (12 ft).
If you have questions about the type of power cord to use, contact an HP authorized service provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items placed upon
or against them. Pay particular attention to the plug, electrical outlet, and the point where the cords
exit from the product.

Japanese power cord notice

Batteries, battery packs, and accumulators should not be disposed of together with the
general household waste. To forward them to recycling or proper disposal, please use the
public collection system or return them to HP, an authorized HP Partner, or their agents.
The Taiwan EPA requires dry battery manufacturing or importing
firms in accordance with Article 15 of the Waste Disposal Act to
indicate the recovery marks on the batteries used in sales, giveaway
or promotion. Contact a qualified Taiwanese recycler for proper
battery disposal.
HP StorageWorks DC and DC04 SAN Backbone Director Switches 237