Taiwan Battery Recycling Notice; Power Cords - HP StorageWorks 8/40 - SAN Switch Hardware Reference Manual

Storageworks 8-gb san switch series
Hide thumbs Also See for StorageWorks 8/40 - SAN Switch:
Table of Contents

Advertisement

WARNING!
Your switch contains an internal lithium manganese dioxide, a vanadium pentoxide, or an alkaline
battery pack. There is risk of fire and burns if the battery pack is not properly handled. To reduce the
risk of personal injury:
Do not attempt to recharge the battery.
Do not expose to temperatures higher than 60°C.
Do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.
Replace only with the HP spare part designated for this product.
Batteries, battery packs, and accumulators should not be disposed of together with the general
household waste. To forward them to recycling or proper disposal, please use the public collection
system or return them to HP, an authorized HP Partner, or their agents.
For more information about battery replacement or proper disposal, contact an HP authorized reseller
or service provider.

Taiwan battery recycling notice

The Taiwan EPA requires dry battery manufacturing or importing firms in accordance with Article 15
of the Waste Disposal Act to indicate the recovery marks on the batteries used in sales, giveaway,
or promotion. Contact a qualified Taiwanese recycler for proper battery disposal.

Power cords

The power cord set must meet the requirements for use in the country where the product was purchased.
If the product is to be used in another country, purchase a power cord that is approved for use in that
country.
The power cord must be rated for the product and for the voltage and current marked on the product
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage
and current rating marked on the product. In addition, the diameter of the wire must be a minimum
2
of 1.00 mm
ft). If you have questions about the type of power cord to use, contact an HP authorized service
provider.
or 18 AWG, and the length of the cord must be between 1.8 m, (6 ft) and 3.6 m (12
8-Gb SAN Switch hardware reference manual
97

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents