Taiwan Battery Recycling Notice; Power Cords; Japanese Power Cord Statement - HP AA-RWF3A-TE Installation Manual

Hewlett-packard san switch installation guide
Table of Contents

Advertisement

Taiwan battery recycling notice

The Taiwan EPA requires dry battery manufacturing or importing firms in accordance
with Article 15 of the Waste Disposal Act to indicate the recovery marks on the batteries
used in sales, givaway, or promotion. Contact a qualified Taiwanese recycler for
proper battery disposal.

Power cords

The power cord set must meet the requirements for use in the country where the product
was purchased. If the product is to be used in another country, purchase a power cord
that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on
the product electrical ratings label. The voltage and current rating of the cord should
be greater than the voltage and current rating marked on the product. In addition, the
diameter of the wire must be a minimum of 1.00 mm
cord must be between 1.8 m, (6 ft) and 3.6 m (12 ft). If you have questions about the
type of power cord to use, contact an HP authorized service provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items
placed upon or against them. Pay particular attention to the plug, electrical outlet, and
the point where the cords exit from the product.

Japanese power cord statement

or 18 AWG, and the length of the
2
SAN Switch installation guide
119

Advertisement

Table of Contents
loading

Table of Contents