Replacing A Power Supply; Removing A Power Supply; Installing A Power Supply; Power Supply Identification - HP A7533A - Brocade 4Gb SAN Switch Base Hardware Reference Manual

8. Replace the chassis door. See

Replacing a power supply

The DC04 SAN Director can continue operating during the replacement if at least one power supply
continues operating. The replacement procedure for each power supply takes less than five minutes.
A power supply unit or filler panel is required for the power supply replacement.
Figure 69 shows the location and identification of the power supplies.
Figure 69 Power supply identification
1. Power supply 1 (PS1)

Removing a power supply

To remove a power supply:
CAUTION:
Wear a grounded ESD strap when handling DC04 SAN Director components. The DC04 SAN Director
chassis provides a grounding connection above the power connectors. Also, store ESD-sensitive
components in antistatic packaging.
1. If the DC04 SAN Director is not operating during the replacement procedure, go to step 2.
If the DC04 SAN Director is going to continue operating during the replacement, check the power
LEDs to verify that the minimum number of power supplies is functioning. A fully populated DC04
SAN Director requires a minimum of one power supply slot at all times to ensure power to the
DC04 SAN Director.
2. Turn off the power switch.
3. Remove the power cord.
4. Loosen the thumb screw.
5.
Grasp the handle and pull, sliding the power supply from the chassis and supporting the power
supply from beneath as you remove it (see
6. If you are not replacing the power supply, insert a filler panel into the slot.

Installing a power supply

To install a power supply:
1.
Remove any filler panel.
184 Replacing DC04 SAN Director field-replaceable units (FRUs)
"Installing the chassis door" on page 170.
2. Power supply 2 (PS2)
Figure 70).