Site Preparation, Unpacking The Dc04 San Director - HP A7533A - Brocade 4Gb SAN Switch Base Hardware Reference Manual
Hp storageworks dc and dc04 san backbone director switches hardware reference guide (5697-7814, february 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- User manual (248 pages) ,
- Release note (76 pages)
Table of Contents
Advertisement
Installation task
Installing power cables and
powering on the DC04 SAN Dir-
ector
Installing SFPs
Attaching fiber optic cables, cable
ties, and cable guides
Establishing serial connection,
logging on to DC04 SAN Direct-
or, and configuring IP addresses
Installing Ethernet cable(s) and
configuring the DC04 SAN Direct-
or name, policies, domain ID,
PIDs, date and time and addition-
al system parameters
Site preparation, unpacking the DC04 SAN Director
IMPORTANT:
See
"Regulatory compliance and safety
setting up your DC04 SAN Director.
The following steps are required to ensure correct installation and operation:
1.
Provide a space that is 9 rack units (9U) high, 61.19 cm (24.09 in.) deep, and 43.74 cm (17.22
in.) wide. 1U is equal to 4.45 cm (1.75 in.)
2.
The DC04 SAN Director can be installed facing in either direction, provided that serviceability
and cooling requirements are met.
3.
Plan for cable management before installing the chassis.
Cables can be managed in a variety of ways, such as by routing cables below the chassis, to
either side of the chassis, through cable channels on the sides of the cabinet, or by using patch
panels (see
126
DC04 SAN Director Installation
Time estim-
ate
20 minutes
30 minutes
60 minutes
20 minutes
20 minutes
notices" on page 229 for important safety guidelines before
"Managing
cables" on page 139).
Items required
Power cables and serial cable (provided in the DC04
SAN Director accessory kit)
SFP optical transceivers
Fiber optic cables and cable ties
Serial cable (provided in the DC04 SAN Director
accessory kit)
Workstation computer with a serial port or terminal
server port and a terminal emulator application (such
as HyperTerminal)
Ethernet IP addresses for the DC04 SAN Director
Ethernet cabling (optional) for Telnet access. All other
configuration parameters optional. Refer to the HP
StorageWorks Fabric OS 6.2.x administrator guide
for Port Identifier (PID) information.
Advertisement
Table of Contents
