HP A7533A - Brocade 4Gb SAN Switch Base Hardware Reference Manual page 146
Hp storageworks dc and dc04 san backbone director switches hardware reference guide (5697-7814, february 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- User manual (248 pages) ,
- Release note (76 pages)
Table of Contents
Advertisement
1.
Verify that the DC04 SAN Director is powered on and that POST is complete by verifying that
all power LED indicators on the port, control processor, and core switch blades display a steady
green light.
2.
Remove the shipping cap from the CONSOLE port on the active CP. Use the serial cable provided
with the DC04 SAN Director to connect the CONSOLE port on the active CP to a computer
workstation. The active CP blade is indicated by an illuminated (blue) LED.
NOTE:
The CONSOLE port is intended primarily for the initial setting of the IP address and for
service purposes.
3.
Access the DC04 SAN Director using a terminal emulator application (such as HyperTerminal
in a Windows environment or TERM in a UNIX environment).
4.
Disable any serial communication programs running on the workstation (such as synchronization
programs).
5.
Open the terminal emulator application and configure as follows:
For most MS Windows systems:
Bits per second—9600
Databits—8
Parity—None
Stop bits—1
Flow control—None
For most UNIX systems, type the following string at the prompt:
tip /dev/ttyb -9600
When the terminal emulator application stops reporting information, press Enter. You will receive
the following login prompt:
CP0 Console Login:
6.
Log in to the DC04 SAN Director as admin. The default password is password. At the initial
login, the user is prompted to enter new admin and user passwords.
Fabric OS (swDir)
swDir login: admin
Password:
Please change your passwords now.
Use Control-C to exit or press 'Enter' key to proceed.
Password was not changed. Will prompt again at next login
until password is changed.
swDir:admin>
7.
(Optional) Modify passwords.
Passwords can be 8 to 40 characters long. They must begin with an alphabetic character. They
can include numeric characters, a period (.), or an underscore (_). Passwords are case-sensitive,
and they are not displayed when you enter them on the command line. Make sure to write down
the new passwords and keep this information in a secure location.
To skip modifying the password, press Ctrl-C. For more information on passwords, refer to the
HP StorageWorks Fabric OS 6.2.x administrator guide.
146
DC04 SAN Director log in and configuration
Advertisement
Table of Contents
