4 Monitoring DC SAN Director system
components
This chapter provides the following information on interpreting LEDs to monitor the following DC SAN
Director components:
• "Monitoring Director blade
• "Monitoring Control Processor blade (CP8)
• "Monitoring core switch blade (CR8)
• "Monitoring power supply
• "Monitoring blower assembly
• "Monitoring WWN bezel (logo plate) and WWN card
Introduction
The DC SAN Director is engineered for reliability and requires no routine operational steps or
maintenance. This chapter provides information about determining the status of each component using
LEDs and CLI commands.
Monitoring Director blade status
To determine the status of a Director blade:
1.
Check the LEDs on the blade.
•
Figure 15
•
Figure 16
•
Figure 17
•
Figure 18
•
Figure 19
2.
The LED patterns may temporarily change during POST and other diagnostic tests. For information
about how to interpret the LED patterns, see
3.
Type slotShow to check blade status.
Table 9
those patterns.
status" on page 57
status" on page 68
status" on page 69
shows the FC8-16
shows the FC8-32
shows the FC8-48
shows the FC10-6
shows the FR4-18i
on page 63 describes the Director blade LED patterns and the recommended actions for
HP StorageWorks DC and DC04 SAN Backbone Director Switches
status" on page 64
status" on page 66
status" on page 71
Table
9.
57