Taiwan Battery Recycling Notice; Power Cords; Japanese Power Cord Statement; Waste Electrical And Electronic Equipment Directive - HP 1606 Hardware Reference Manual

Taiwan battery recycling notice

The Taiwan EPA requires dry battery manufacturing or importing firms in accordance with Article 15
of the Waste Disposal Act to indicate the recovery marks on the batteries used in sales, giveaway,
or promotion. Contact a qualified Taiwanese recycler for proper battery disposal.

Power cords

The power cord set must meet the requirements for use in the country where the product was purchased.
If the product is to be used in another country, purchase a power cord that is approved for use in that
country.
The power cord must be rated for the product and for the voltage and current marked on the product
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage
and current rating marked on the product. In addition, the diameter of the wire must be a minimum
2
of 1.00 mm
ft). If you have questions about the type of power cord to use, contact an HP authorized service
provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items placed upon
or against them. Pay particular attention to the plug, electrical outlet, and the point where the cords
exit from the product.

Japanese power cord statement

Waste Electrical and Electronic Equipment directive

English notice

Disposal of waste equipment by users in private households in the European Union
This symbol on the product or on its packaging indicates that this product must not be disposed
of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment
by handing it over to a designated collection point for recycling of waste electrical and electronic
equipment. The separate collection and recycling of your waste equipment at the time of disposal will
help to conserve natural resources and ensure that it is recycled in a manner that protects human
or 18 AWG, and the length of the cord must be between 1.8 m, (6 ft) and 3.6 m (12
8-Gb SAN Switch Hardware Reference Guide 103