Static Route Configuration - NETGEAR SSL312-100NAS - ProSafe SSL312 SSL VPN Concentrator 25 User Manual

Ssl312 user manual
Table of Contents

Advertisement

NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
5. Enter the subnet mask. The subnet mask specifies the network number portion of an IP
address. The factory default is 255.255.255.0.
6. Click Apply to save your settings.
From the Network screen, you can define the default network route. The default route is required
for Internet access.
1. In the Default Gateway section, enter the IP address of the router or default gateway of the
network in the Default Gateway Address field.
The default gateway address is the same gateway address used by local area network
computers to connect to the Internet and it may be the address of a network firewall.
2. From the Interface pull-down menu, select the Ethernet interface (ethernet-1 or ethernet-2)
that should be used to connect to the default gateway address.
3. Click Apply to save your settings.
Note: The SSL VPN Concentrator does not perform Network Address Translation
(NAT). And the SSL VPN Concentrator only enforces access policies on SSL
VPN traffic, not on other TCP/IP protocols. Therefore, the SSL VPN
Concentrator should be used in conjunction with a network firewall.
If the interface is configured to terminate SSL VPN connections, then restart the SSL VPN
Concentrator software for the change to take effect.
Note: The SSL VPN Concentrator administrative session will end when the software
is restarted. To log in to the SSL VPN Concentrator management interface,
enter the new IP address of the SSL VPN Concentrator device in the Address
or Location field of your web browser. Be sure that the management station is
in the same subnet as the new SSL VPN Concentrator IP address.
To complete the IP settings configuration, also configure SSL VPN Concentrator DNS settings
and network routes.

Static Route Configuration

If your corporate network contains other subnets whose resources will be made available through
remote SSL connections, you must configure static routes to those subnets.
7-4
v2.1, November 2008
Additional System Configuration

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prosafe ssl312Prosafe ssl vpn concentrator 25

Table of Contents