Web Access - NETGEAR GS748AT - ProSafe Gigabit Smart Switch Administration Manual

Web Access

For Web access, you can either:
• Select Web Access using the Smart Wizard Discovery utility (see
Server" or "Network without a DHCP
• Access the switch directly, without using the Smart Wizard Discovery utility.
You must work from the same network segment that contains the switch (i.e., the subnet mask
values of switch and PC host must be the same) and you must point your browser using the switch
IP address. If you used the Smart Wizard Discovery utility to set up IP address and subnet mask,
either with or without DHCP server, use that IP address in your browser window.
If you are starting with an "out of the box" switch and are not using the Smart Wizard Discovery
utility, you must initially configure your host PC to be on a network segment to match the default
parameters of the switch, which are:
• IP address: 192.168.0.239
• Subnet Mask: 255.255.255.0
You can change the network parameters to match those of your network (this procedure is
described in Chapter 3, "Managing System
then be set to match your network.
Clicking Web Access on the Smart Wizard Discovery utility or accessing the switch directly
displays the screen shown below.
.
Figure 1-5
Use this screen to proceed to management of the switch covered in
Web Browser Interface".
Getting Started with Switch Management
GS700AT Smart Switch Software Administration Manual
Server").
Settings"). Your host PC network parameters must
v1.0, October 2008
"Network with a DHCP
Chapter 2, "Introduction to the
1-8