NETGEAR GS748AT - ProSafe Gigabit Smart Switch Administration Manual page 18

GS700AT Smart Switch Software Administration Manual
NIC Setting on the Host that Accesses the GS700AT Gigabit
Smart Switch
The settings of your Network Interface Card (NIC) under MS Windows OS are made with entries
into Windows screens similar to the ones shown below. For comparison, the settings screens of the
switch are also shown although they do not appear in the Windows view.
Figure 1-4
You need Windows Administrator privileges to change these settings.
1. On your PC, access the MS Windows operating system TCP/IP Properties.
2. Set IP address and subnet mask appropriately. The subnet mask value is identical to that set in
the switch. The PC IP address must be different from that of the switch but lie in the same
subnet.
3. Click Web Access in the Smart Wizard Discovery utility to enable the management screens as
described in the following section.
1-7 Getting Started with Switch Management
v1.0, October 2008