Server Log - NETGEAR GS748AT - ProSafe Gigabit Smart Switch Administration Manual

– Error – A device error has occurred; for example, if a single port is offline.
– Warning – The lowest level of a device warning. The device is functioning, but an
operational problem has occurred.
– Notice – Provides device information.
– Informational – Provides device information.
– Debug – Provides debugging messages.
• Description – Displays the log message text.
2. Click REFRESH or CLEAR LOGS to refresh or reset the Flash Logs screen.

Server Log

The Server Log screen contains information for viewing and configuring the remote log servers.
New log servers can be defined and the log severity sent to each server.
To configure remote log servers:
1. Click Monitoring > Logs > Server Log. The Server Log screen displays:
Figure 7-5
The Server Log screen contains the following fields:
• Server IP – Enter the server's IP address to which logs can be sent.
• UDP Port – Enter the UDP port to which the server logs are sent. The possible range is 1
- 65535. The default value is 514.
• Facility – Select an application from which system logs are sent to the remote server.
Only one facility can be assigned to a single server. If a second facility level is assigned,
the first facility is overridden. All applications defined for a device utilize the same facility
on a server. The field default is Local 0. The possible field values are Local 0 - Local 7.
Monitoring the Switch
GS700AT Smart Switch Software Administration Manual
v1.0, October 2008
7-7