NETGEAR GS748AT - ProSafe Gigabit Smart Switch Administration Manual page 54

GS700AT Smart Switch Software Administration Manual
To remove an SNMPv3 user:
1. Click System > SNMP > SNMPv3 > Users Configuration. The SNMPv3 User
Configuration screen displays.
2. Select the user entry.
3. Click DELETE to remove the entry.
Global Trap Configuration
The SNMPv3 Global Trap Settings screen contains parameters for defining SNMP notification
parameters.
To configure SNMP notification global parameters:
1. Click System > SNMP > SNMPv3 > Global Trap Configuration. The SNMPv3 Global
Trap Settings screen displays:
Figure 3-14
The SNMPv3 Global Trap Settings screen contains the following fields:
• SNMP Notifications – Select whether or not the device can send SNMP notifications.
The possible field values are:
– Enable – Enable SNMP notifications.
– Disable – Disable SNMP notifications.
• Authentication Notifications – Select the SNMP authentication failure notification status
on the device. The possible field values are:
– Enable – Enable the device to send authentication failure notifications.
– Disable – Disable the device from sending authentication failure notifications.
3-45
v1.0, October 2008
Managing System Settings