NETGEAR GS748AT - ProSafe Gigabit Smart Switch Administration Manual page 154

GS700AT Smart Switch Software Administration Manual
– Forward – Forward packets from an unknown source without learning the MAC
address.
– Discard – Discard packets from any unlearned source. This is the default value.
– Shutdown – Discard packets from any unlearned source and shut down the port. The
port remains shut down until reactivated or until the device is reset.
• Trap – Select whether traps are enabled or disabled when a packet from an unknown
source is received on a locked port. The possible field values are:
– Enable – Enable traps.
– Disable – Disable traps. This is the default value.
• Trap Frequency (Sec) – Enter the frequency at which traps are sent. The field format is in
seconds. The range is 1-1,000,000. The default value is 10 seconds.
2. Select the port security Status, Learning Mode, Action and Trap status from the lists in the
provided fields in the first row.
3. Enter the Max Entries and Trap Frequency in the provided fields in the first row.
4. Click APPLY to update the device.
6-18
v1.0, October 2008
Managing Security