NETGEAR GS748AT - ProSafe Gigabit Smart Switch Administration Manual page 117

Software administration manual
Hide thumbs Also See for GS748AT - ProSafe Gigabit Smart Switch:
Table of Contents

Advertisement

GS700AT Smart Switch Software Administration Manual
The Advanced IGMP Snooping Configuration screen contains the following fields:
IGMP Snooping Configuration
Status – Select the IGMP Snooping status on the device. IGMP Snooping is operational if
both the Status and Bridge Multicast Filtering fields are enabled. The possible field values
are:
Enable – Enable IGMP Snooping on the device.
Disable – Disable IGMP Snooping on the device.
Bridge Multicast Filtering Status – Select the bridge Multicast filtering status on the
device. The possible field values are:
Enable – Enable Multicast filtering on the device.
Disable – Disable Multicast filtering on the device. If Multicast filtering is disabled,
Multicast frames are flooded to all ports in the relevant VLAN. Disabled is the default
value.
Interface Settings
VLAN ID – Displays the VLAN ID.
Status – Select the IGMP Snooping status on the VLAN. The possible field values are:
Enable – Enable IGMP Snooping on the VLAN.
Disable – Disable IGMP Snooping on the VLAN.
Auto Learn – Select the Auto Learn status on the device. If Auto Learn is enabled, the
devices automatically learns where other Multicast groups are located. The possible field
values are:
Enable – Enable auto learn.
Disable – Disable auto learn.
Host Timeout – Enter the amount of time in seconds the host waits to receive a message
before timing out. The default value is 260 seconds.
MRouter Timeout – Enter the amount of the time in seconds the Multicast router waits to
receive a message before it times out. The default value is 300 seconds.
Leave Timeout – Enter the amount of time in seconds the host waits, after requesting to
leave the IGMP group and not receiving a Join message from another station, before
timing out. If a Leave Timeout occurs, the switch notifies the Multicast device to stop
sending traffic The field range is 0 - 2147483647. The default value is 10 seconds.
Configuring Switching Settings
v1.0, October 2008
4-40

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gs748at-100nasGs700at smart switch

Table of Contents