NETGEAR GS748AT - ProSafe Gigabit Smart Switch Administration Manual page 65

To define LLDP Port Properties:
1. Click System > LLDP > Advanced > LLDP Port Settings. The LLDP Port Settings screen
displays:
Figure 3-20
The LLDP Port Settings screen contains the following fields:
• Interface – Displays the specific interface for which LLDP parameters are defined.
• Admin Status – Select the LLDP packet transmitting and receiving status of the interface.
The possible field values are:
– Tx Only – Enable transmitting LLDP packets only.
– Rx Only – Enable receiving LLDP packets only.
– Tx & Rx – Enable transmitting and receiving LLDP packets.
– Disable – Disable LLDP on the interface.
• Management IP Address – Select the management IP address that is advertised from the
interface. The possible field values are:
– StopAdvertise – Stop advertising the management IP address from the interface.
– AutoAdvertise – Advertise the device's current IP address as the management IP
address.
• Notification – Select the topology change notification status on the interface.
– Enable – Enable topology change notification on the interface. This is the default
value.
Managing System Settings
GS700AT Smart Switch Software Administration Manual
v1.0, October 2008
3-56