Sample Configuration; Managing The Catalyst 4224 Access Gateway Switch - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Managing the Catalyst 4224 Access Gateway Switch

Sample Configuration

Note
Managing the Catalyst 4224 Access Gateway Switch
Note
Catalyst 4224 Access Gateway Switch Software Configuration Guide
3-10
The following example illustrates the configuration on the IP phone:
interface FastEthernetx/x
switchport voice vlan x
The following example illustrates the configuration on the PC:
interface FastEthernetx/y
switchport access vlan y
Using a separate subnet, and possibly a separate IP address space, may not be an
option for some small branch offices due to the IP routing configuration. If the IP
routing can handle an additional subnet at the remote branch, you can use Cisco
Network Registrar and secondary addressing.
This section illustrates how to perform basic management tasks on the
Catalyst 4224 with the Cisco IOS command-line interface (CLI). You might find
this information useful when you configure the switch for the previous scenarios.
For reference information on the voice commands used in this section, refer to the
Appendix A, "Command Reference for Voice VLAN."
This section contains the following topics:
Adding Trap Managers, page 3-11
•
Configuring IP Information, page 3-11
•
• Configuring Voice Ports, page 3-14
Enabling and Disabling Switch Port Analyzer, page 3-16
•
Managing the ARP Table, page 3-17
•
Managing the MAC Address Tables, page 3-18
•
Chapter 3 Configuring Ethernet Switching
OL-2031-02