Mgcp Configuration - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Chapter 5 Configuring the Voice Interfaces
Step 7
Step 8

MGCP Configuration

OL-2031-02
To see the current operating configuration, including any changes you just made,
enter the show running-config command:
c4224# show running-config
To see the configuration currently stored in non-volatile random access memory
(NVRAM), enter the show startup-config command at the enable prompt:
c4224# show startup-config
The results of the show running-config and show startup-config commands
differ from each other if you have changed the configuration but have not yet
written the changes to NVRAM. To write your changes to NVRAM and make
them permanent, enter the copy running-config startup-config command at the
enable prompt:
c4224# copy running-config startup-config
Building configuration. . .
[OK]
c4224#
If you want to use Media Gateway Control Protocol (MGCP), configuration of the
Catalyst 4224 differs depending on whether you are using it with
Cisco CallManager 3.0 or 3.1.
With Cisco CallManager 3.1 and later, you can create the MGCP gateway
configuration on the Cisco CallManager server and download the configuration to
the Catalyst 4224. For the details of this configuration procedure, refer to the
Cisco CallManager 3.1 online help and to Configuring Cisco IP Telephony
Gateways, available online at Cisco.com.
With Cisco CallManager 3.0, you must configure each voice port for MGCP on
the Catalyst 4224 and then duplicate this configuration in Cisco CallManager
Administration.
This section contains the following Catalyst 4224 configuration topics:
Enabling MGCP, page 5-4
•
• Configuring FXS and FXO Analog Ports, page 5-8
Catalyst 4224 Access Gateway Switch Software Configuration Guide
MGCP Configuration
5-3