Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual page 98

Configuring ISDN BRI Interfaces
Task
Step 1
Enter enable mode.
Enter the password.
You know you have entered enable mode when the prompt
changes to
gateway#
Step 2 Enter global configuration mode.
You know you have entered global configuration mode
when the prompt changes to
Step 3 Enter an ISDN switch type. See
switch types.
Switch types configured in interface
Note
configuration mode override this setting for the
configured interface.
Step 4
Enable routing protocols as required for your global
configuration.
Step 5 Enter the interface configuration mode.
You know you have entered interface configuration mode
when the prompt changes to
Step 6
Enable encapsulation. For data, you need to change the
encapsulation to hdlc, ppp, or frame-relay. The default is
voice.
Step 7 Assign the IP address and subnet mask to the interface.
If you are configuring this interface for voice, enter the
switch type instead of an IP address.
Step 8 Exit back to global configuration mode.
If your Catalyst 4224 has more than one BRI interface that
you need to configure, repeat Step 5 through Step 7.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
4-10
To configure ISDN BRI interfaces, perform the following steps:
.
gateway(config)#.
Table 4-2
gateway(config-if)#.
Chapter 4
Command
gateway> enable
Password:
gateway#
gateway# configure terminal
Enter configuration
commands, one per line. End
with Ctrl-Z.
gateway(config)#
for a list of ISDN
gateway(config)# isdn
switch-type switch-type
gateway(config)# ip routing
gateway(config)# interface
bri 2/0
gateway(config-if)#
gateway(config)# encaps
encaps-type
gateway(config-if)# ip
address 172.16.74.2
255.255.255.0
gateway(config-if)# isdn
switch-type basic-5ess
gateway(config-if)# exit
Configuring the Data Interfaces
< >
password
OL-2031-02