Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual page 130

Chapter 5 Configuring the Voice Interfaces
Configuring T1-CAS Analog Emulation (H.323)
endpoints on a Catalyst 4224. If you configure Cisco CallManager as an H.323
endpoint, you must use Cisco CallManager Administration to define the route
patterns required to route calls to the Catalyst 4224.
The following example illustrates how to configure a single DS-0 group. Repeat
the relevant commands to configure additional groups. This example is for a
scenario in which all of the POTS devices connected to a T1 channel bank are
configured with a destination number beginning with 526. In this example,
Cisco CallManager has the host name CCM30 and is configured as an H.323
endpoint that manages all the telephones and other devices on the IP network. The
devices on the IP network have numbers beginning with 525.
c4224(config)# interface FastEthernet5/0
c4224(config)# ipaddress 172.20.71.48 255.255.255.0
c4224(config)# no ip directed-broadcast
c4224(config)# no keepalive
c4224(config)# duplex auto
c4224(config)# speed 10
c4224(config)# controller T1 1/0
c4224(config-controller)# framing esf
c4224(config-controller)# clock source internal
c4224(config-controller)# linecode b8zs
c4224(config-controller)# dso-group 0 timeslots 1 type fxo-loop-start
c4224(config)# dial-peer voice 1 pots
c4224(config-dial-peer)# destination-pattern 526....
c4224(config-dial-peer)# port 1/0:0
c4224(config-dial-peer)# destination-pattern 525....
c4224(config-dial-peer)# session target dns:CCM30
c4224(config-dial-peer)# codec g711u1aw
c4224# line con 0
c4224# transport input none
c4224# line aux 0
c4224# line vty 0 4
c4224# login
c4224# no scheduler allocate
c4224# end
c4224# copy running-config startup-config
Building configuration. . .
[OK]
c4224#
Catalyst 4224 Access Gateway Switch Software Configuration Guide
5-22
OL-2031-02