Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual page 39

Chapter 1 Product Overview
•
•
The following sample configuration shows DSP allocations:
C4224# sh voice dsp
TYPE DSP CH CODEC
==== === == ======== ==== ===== ======= === == ======= ==
5409 001 00 {anlgHC}
5409 002 00 {anlgMC}
5409 003 04 {anlgMC}
5409 004 00 {medium}
5409 005 00 {medium}
5409 006 00 {medium}
In the sample configuration, port 3/0 is an analog VIC that uses two of the four
channels in DSP 1. Slot 4 contains the eight-port FXS Module. This module takes
up two DSPs. DSP four, five, and six are being used for the 12 voice channels on
a MFT VWIC.
DSP resources are used for signaling and voice bearer channels. The signaling
channel is used for detecting off-hook/on-hook transitions.
OL-2031-02
The two-Port FXS and FXO VIC uses two of the available four DSO
channels. The DSP is used when the VIC is plugged in, even if the ports are
not configured.
The eight-Port FXS Module uses eight DS0 channels or two DSPs, even if it
is not used (unless it is disabled using the CLI).
VERS STATE STATE
01 {anlgHC}
01 {anlgMC}
02 {anlgMC}
03 {anlgMC}
05 {anlgMC}
06 {anlgMC}
07 {anlgMC}
3.5 IDLE
01 {medium}
02 {medium}
03 {medium}
3.5 IDLE
01 {medium}
02 {medium}
03 {medium}
3.5 IDLE
01 {medium}
02 {medium}
03 {medium}
Catalyst 4224 Access Gateway Switch Software Configuration Guide
BOOT
RST AI PORT
.8 IDLE idle 0
.8 IDLE idle 0
.3 IDLE idle 0
.3 IDLE idle 0
.3 IDLE idle 0
.3 IDLE idle 0
.3 IDLE idle 0
.3 IDLE idle 0
.3 IDLE idle 0
.3 IDLE idle 0
idle 0
.8 IDLE idle 0
IDLE idle 0
IDLE idle 0
idle 0
.8 IDLE idle 0
IDLE idle 0
IDLE idle 0
idle 0
.8 IDLE idle 0
IDLE idle 0
IDLE idle 0
Application Notes
TS
0 3/0 0
0 3/1 0
0 4/0 0
0 4/1 0
0 4/2 0
0 4/3 0
0 4/4 0
0 4/5 0
0 4/6 0
0 4/7 0
0 2/0:1 1
0 2/0:1 2
0 2/0:1 3
0 2/0:1 4
0 2/0:1 5
0 2/0:1 6
0 2/0:1 7
0 2/0:1 8
0 2/0:1 9
0 2/0:1 10
0 2/0:1 11
0 2/0:1 12
1-13