Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual page 195

Chapter 7 Configuring the Eight-Port FXS RJ-21 Module
Figure 7-1 Configuration for Connecting Faxs through Catalyst 4224
Fax 1
FXS port
1/1/0
Destination
1
Dial-Peer Tag Pattern
For Cisco 2610
1 10
2 20
For Eight-Port RJ-21 FXS Module
1 20
2 10
1. Assigns a unique number (1, 2,...) to a dial peer. Has only local significance.
2. Assigns phone numbers to dial peers. The router directs voice calls based on these patterns.
OL-2031-02
In the sample configuration illustrated in
an FXS port to the Cisco 2610 router. The router is connected through
Fast Ethernet to the eight-port FXS module, which is connected through an FXS
port to Fax2.
This section includes the following configuration-related samples:
Cisco 2600 Sample Configuration, page 7-10
•
FXS Module Sample Configuration, page 7-10
•
• Displaying Cisco 2600 Configuration Values, page 7-11
Displaying FXS Module Configuration Values, page 7-12
•
Cisco 2601
The following template can be used to implement this configuration:
2
Type
POTS
VoIP
POTS
VoIP
Catalyst 4224 Access Gateway Switch Software Configuration Guide
Figure
Catalyst 4224
FXS port
V
4/0
Session
Voice Port Target
1/1/0 —
— 172.20.59.93
4/0 —
— 172.20.59.61
Sample Configuration
7-1, Fax1 is connected through
Fax 2
3
codec
G.711
(default)
G.729
(default)
G.711
(default)
G.729
(default)
7-9