Displaying Fxs Module Configuration Values - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Chapter 7 Configuring the Eight-Port FXS RJ-21 Module
Sample Configuration
>ip classless
>ip route 8.1.1.0 255.255.255.0 30.1.1.1
>no ip http server
>!
>snmp-server packetsize 4096
>call rsvp-sync
>!
>voice-port 1/1/0
>!
>voice-port 1/1/1
>!
>dial-peer cor custom
>!
>dial-peer voice 1 pots
> destination-pattern 10
> port 1/1/0
>!
>dial-peer voice 2 voip
> destination-pattern 20
> session target ipv4:172.20.59.93
>!
>line con 0
> transport input none
>line aux 0
>line vty 0 4
> login
>!
>end

Displaying FXS Module Configuration Values

To display the values configured on the eight-Port RJ-21 FXS module, use the
show running-config command, as follows:
>--------------------
>Gateway# sh running-config
>Building configuration...
>
>Current configuration :1062 bytes
>!
>version 12.1
>no service single-slot-reload-enable
>no service pad
>service timestamps debug uptime
>service timestamps log uptime
Catalyst 4224 Access Gateway Switch Software Configuration Guide
7-12
OL-2031-02