Appendix A
Command Reference for Voice VLAN
Defaults
Command Modes
Usage Guidelines
Example
OL-2031-02
The switch default is not to configure the telephone automatically (none).
The Cisco 7960 IP Phone default is to generate an 802.1Q/802.1P frame.
Interface configuration.
Ports that are not configured as trunk ports but have a configured voice VLAN are
access ports with a voice VLAN ID (VVID).
The following example shows how to configure VLAN 2 as the voice VLAN:
Switch(config-if)# switchport voice vlan 2
You can verify the previous command by entering the show interface interface-id
switchport command in privileged EXEC mode.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
switchport voice vlan
A-11