Configuring Asynchronous/Synchronous Serial Interfaces - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

Configuring Asynchronous/Synchronous Serial Interfaces

Configuring Asynchronous/Synchronous Serial
Interfaces
Note
Timesaver
Task
Step 1
Enter enable mode.
Enter the password.
You know you have entered enable mode when the prompt
changes to
gateway#
Step 2
Enter global configuration mode.
You know you have entered global configuration mode
when the prompt changes to
Step 3 Enable routing protocols as required for your global
configuration.
Catalyst 4224 Access Gateway Switch Software Configuration Guide
4-6
This section describes how to configure the serial interfaces on your
asynchronous/synchronous serial WIC.
The asynchronous/synchronous serial WIC supports synchronous
mode only. At this time, asynchronous mode is not supported.
Before you begin, disconnect all WAN cables from the Catalyst 4224 to keep it
from running the AutoInstall process. The Catalyst 4224 attempts to run
AutoInstall if there is a WAN connection on both ends and the Catalyst 4224 does
not have a valid configuration file stored in NVRAM. The Catalyst 4224 can take
several minutes to determine that AutoInstall is not connected to a remote TCP/IP
host.
To configure the serial interfaces, perform these steps:
.
gateway(config)#.
Chapter 4 Configuring the Data Interfaces
Command
gateway> enable
Password: <password>
gateway#
gateway# configure terminal
Enter configuration
commands, one per line. End
with Ctrl-Z.
gateway(config)#
gateway(config)# ip routing
OL-2031-02