Configuring Fxs And Fxo Analog Ports; Configuring T1-Cas E&M Emulation - Cisco WS C4224V 8FXS - 200Mbps Ethernet Switch Software Configuration Manual

MGCP Configuration

Configuring FXS and FXO Analog Ports

Configuring T1-CAS E&M Emulation
Catalyst 4224 Access Gateway Switch Software Configuration Guide
5-8
Current state: Automatic Configuration Download feature is disabled
Configuration Error History:
FAX relay mode: cisco-fax-relay
You use the same commands to configure both Foreign Exchange Service (FXS)
and Foreign Exchange Office (FXO) ports. The gateway recognizes the type of
voice interface card that is installed in each voice network module and applies the
configuration you enter based on the port position you specify in the command.
To enable FXS or FXO ports with MGCP, enter the following commands:
Gateway(config)# dial-peer voice number pots
Gateway(config-dial-peer)# application MGCPAPP
Gateway(config-dial-peer)# port portnumber
To use these commands, replace number with a unique numeric ID, and replace
portnumber with the port identifier in the form slot#/voice module#/port#. Use the
application MGCPAPP command to place the port under control of the
Cisco CallManager MGCP call agent.
For example, the following command string configures voice port 0 in voice
interface card 1 with MGCP:
Gateway(config)# dial-peer voice 1 pots
Gateway(config-dial-peer)# application MGCPAPP
Gateway(config-dial-peer)# port 1/1/0
You can use MGCP with the following emulation types:
E&M Wink Start
•
E&M Delay Start
•
Chapter 5 Configuring the Voice Interfaces
OL-2031-02