Table of Contents
Advertisement
Chapter 6
Configuring VoIP
Configure FXS or FXO Voice Ports
Table 6-3
Commands to Configure FXS and FXO Voice Ports
Task
Step 1
Enter the global configuration mode.
Step 2
Identify the voice port you want to
configure, and enter the voice port
configuration mode.
Step 3
(For FXO ports only) Select the appropriate
dial type for out-dialing.
Step 4
Select the appropriate signal type for this
interface.
Step 5
Select the appropriate voice call progress
tone for this interface.
The default for this command is us.
Step 6
(For FXS ports only) Select the ring
frequency (in Hz) specific to the equipment
attached to this voice port and appropriate
to the country you are in.
OL-2031-02
FXO—The foreign exchange office interface uses a RJ-11 modular telephone
•
cable to connect local calls to a PSTN central office or to a PBX that does not
support E&M signaling. This interface is used for off-premise extension
applications.
E&M—The E&M interface uses an RJ-48 telephone cable to connect remote
•
calls from an IP network to PBX trunk lines (tie lines) for local distribution.
It is a signaling technique for two-wire and four-wire telephone and trunk
interfaces.
Under most circumstances, the default voice port values are adequate to configure
FXS and FXO ports to transport voice data over your existing IP network.
However, if you need to change the default configuration for these voice ports,
use the commands outlined in
Catalyst 4224 Access Gateway Switch Software Configuration Guide
Table
6-3, beginning in privileged EXEC mode:
Required or
Optional
Command
Required
configure terminal
Required
voice-port slot-number/port
Required
dial-type {dtmf | pulse}
Required
signal {loop-start |
ground-start}
Required
cptone country
Required
ring frequency
Configure Voice Ports
{
|
}
25
50
6-23
Advertisement
Table of Contents
Troubleshooting
